Docomo N-04A, Instruction Manual

Page: 293 / 570

291
Osaifu-K
eitai/T
oru
Ca
Launching Osaifu-Keitai
i-
α
ppli
You can launch the Osaifu-Keitai i-
α
ppli from the
software list screen. You can use the Osaifu-Keitai
i-
α
ppli to read and write the data in the IC card to use
useful functions such as charging electronic money,
or browsing the balance and transaction history on
the FOMA terminal.
z
Take great care not to disclose your security code
and passwords of each service to others.
z
The reading/writing of the data from the software to
the IC card is interrupted in the following cases. In
this case, the read/written data is discarded. The
operation after the call varies depending on the
service.
• If you receive a call while launching i-
α
ppli
• If the battery fails
z
When you launch the Osaifu-Keitai i-
α
ppli for the
first time or when downloading the Osaifu-Keitai
i-
α
ppli, the FOMA card information and the IC card
are matched. After this, you cannot use the IC card
function unless the matched FOMA card (UIM) is
inserted.
If you use another FOMA card (UIM), you cannot
use the IC card functions unless you delete (Reset
IC owner) the Osaifu-Keitai i-
α
ppli first. → P.292
1
i
“OSAIFU-KEITAI” “IC card
content”
■
Search the Osaifu-
Keitai i-
α
ppli by i-mode
“Search by i-mode”
“YES”
2 Select the Osaifu-Keitai i-
α
ppli
You can also launch the Osaifu-Keitai i-
α
ppli
from the “Software list screen” (P.267).
Using the Osaifu-Keitai
By holding the “
e
” on the FOMA terminal over the
reader/writer unit, you can pay with the electronic
cash or use the FOMA terminal as a ticket. These
functions can be used without launching the software.
z
Though you cannot launch the Osaifu-Keitai i-
α
ppli
during a call, you can use the Osaifu-Keitai by
holding the
e
over the reader/writer unit.
1 Hold the “
e
” over the reader/
writer unit to use the service you
want
When using Osaifu-Keitai, notification is
performed by Illumination lamp and Vibrator
according to the settings of the “IC card notice
set”, and by “Key illumination” according to the
settings of the “IC Exchanging”.
N
z
When 2in1 is set to B mode, you cannot launch an
i-
α
ppli which uses the mail function.
IC card content
Function menu P.268
N
z
You can use the IC card function by holding the
e
mark over the reader/writer unit even when
the FOMA terminal is turned off or the battery is
low. (You cannot launch the Osaifu-Keitai i-
α
ppli.)
However, you may not be able to use this function
when the battery pack is not attached, the battery
pack is attached but not used for a long period of
time, or when the FOMA terminal is left uncharged
after the battery alarm sounds, so be sure to
charge the battery pack.
z
Do not shock the FOMA terminal when holding
the
e
mark over a reader/writer unit.
z
If the
e
is not recognized, hold the FOMA
terminal close to the reader/writer section of the
unit, move the FOMA terminal back and forth and
around to be parallel to the reader/writer unit.
z
The Osaifu-Keitai i-
α
ppli may be activated when
you hold the
e
mark over the reader/writer.
Holding the
e
(FeliCa mark)
over the reader unit