Delphin ProfiMessage, Hardware Manual

Page: 291 / 322

Profi Message
Sets one of the digital or analogue inputs as the source for measuring rotation
speed to which the FFT analysis is assigned. Key word: Rotation speed stamp for
frequency spectrum and order analysis.
Digital input 1 or 2 should be used as the setting when frequency measurement
takes place via one of these inputs.
Redundancy mode
Two rotation speed sensors and two digital inputs can be operated to achieve
redundancy. Refer here to
Redundant trigger source.
9.3.1.2
I/O module status/measurement block counter
Measurement data is recorded, evaluated and transmitted according to the I/O
module settings and trigger events.
The DataService Configurator program displays a counter for the number of recor-
ded measurement data blocks, as status information for the AMDT I/O module.
9.3.1.3 Configuring/settings for an analogue input
Refer also to the technical specifications for analogue inputs.
Active
Activating this channel transmits the time signal as a measurement data block fol-
lowing each triggering. Unrequired channels should be deactivated.
Additional settings for all “analogue input” channels can be found
in the time signal tab for the I/O module. Refer to section
Con-
figuration/settings for I/O module .
Main settings tab
291
Delphin Technology AG
Dezember 2015
Profi Message Manual