Delphin ProfiMessage, Hardware Manual

Page: 179 / 322

Profi Message
After selecting Slave redundancy , Backup COM-Port shows that the COM2 interface
is used for backups.
Slave redundancy can be selected only when a second interface is
available for backup operations. A second interface must run in
PROFIBUS mode. However, no PROFIBUS protocol is allowed to be con-
figured to this connection. The dialogue notifies of any incorrect set-
tings.
The symbol is then displayed for the channel following configuration. Then
create and configure the required PROFIBUS channels (Signals).
4.8.3.2 PROFIBUS channel
Creating PROFIBUS channels requires creation of a COM connection in the
PROFIBUS interface mode and of a PROFIBUS protocol (subchannel). Select Create
channel
→
PROFIBUS input or PROFIBUS output from the context menu of the
PROFIBUS protocol ( , PROFIBUS protocol) in order to create channels for your
PROFIBUS signals. A PROFIBUS input channel is identified by , and a PROFIBUS
output channel by .
Double-click a PROFIBUS channel or select Properties from the context menu to dis-
play the configuration dialogue. The data to be entered depends on the signal type
that is to be sent to or received from the PROFIBUS user. (Refer to
Using channel as
an output ). Therefore, obtain information on the format and settings of relevant
PROFIBUS signals before entering data here.
Refer also to
Settings for all dialogues .
Main settings tab
179
Delphin Technology AG
Dezember 2015
Profi Message Manual