DayTronic 3500 Series, Instruction Manual

Page: 46 / 122

3.8
3
S
ETUP
: I
NSTRUMENT
C
ONFIGURATION
3.a.5 I
NPUT
R
ANGE
: RANGE K
EY
Once you are in SETUP MODE, press the button labelled
The unit will display the word "RANGE":
—unless it is a Model 3510 Thermocouple Conditioner , in which case it will dis-
play the word "TYPE":
NOW REFER TO THE SECTION BELOW THAT APPLIES TO YOUR SPECIFIC CON-
DITIONER MODEL.
3.a.5.a S
ETTING THE
M
ODEL
3510’
S
TC T
YPE AND
S
CALE
The Model 3510 Thermocouple Conditioner must be set to match the thermo-
couple type to which it is connected.
1. If, after pressing the RANGE button, you want to display the current TC Type
setting, press ENTER . Otherwise, press RANGE again and proceed to Step
4. If, for example, the conditioner is set for a "Type E" thermocouple, after you
press
ENTER it will display
2. To change the TC Type setting, you can cycle forwards or backwards through
the allowed settings ("E," "J," "K," "R," "S," "T," and "B") by pressing the top or
bottom segment, respectively, of any digit display (even if it is blank).
3. When the desired TC Type appears, press ENTER . The unit will display the
word "SCALE":
4. If you want to display the current temperature scale setting, press ENTER .
Otherwise, press RANGE again and proceed to Step 7. If, for example, the
conditioner is set to read temperature measurements in degrees Fahrenheit,
when you press
ENTER it will display
5. To change the temperature scale, you can cycle forwards or backwards
through the allowed settings ("degrees F" and "degrees C") by pressing the
top or bottom segment, respectively, of any digit display (even if it is blank).
3.a C
ONFIGURING
T
HROUGH THE
F
RONT
P
ANEL
RANGE