DayTronic 3500 Series, Instruction Manual

Page: 14 / 122

1.d
P
ANEL
M
OUNTING
You can easily mount the instrument in your own precut panel. Cutout dimen-
sions for a panel-mounted unit are standard
DIN (see Fig. 3); panel thickness
should not exceed 6 mm (0.24 in).
Simply unscrew the two rear-panel CLAMP SCREWS and slide the CLAMP
SLIDES rearwards out of their grooves (THE FRONT BEZEL NEED NOT BE
REMOVED). Insert the unit through the panel cutout, from the front of the panel (if
the unit has rubber feet, these will have to be removed). Then reinstall the
CLAMP SLIDES, and tighten the CLAMP SCREWS until the instrument is securely
mounted.
1.6
1
I
NTRODUCTION
1.d P
ANEL
M
OUNTING
Analog Output
Connector
(see Fig. 16)
AA
AA
Analog Input
Connector**
(see Fig. 7, 8, 9,
or 10)
Logic I/O
Connector
(see Figs. 5, 17)
Fuse
(0.5-amp SLO-
BLO)
ON-OFF
Switch
AC Power
Connector
RS-232/485 Inter-
face Connector
(see Figs. 12 - 14)
Panel-
Mount
Clamp
Screw
ON
OFF
+
+
Analog Output
Programming Pins*
(behind cover plate—see Fig. 15)
+
Not present on the Frequency Conditioner.
The number of connector terminals will vary with the conditioner type.
*
**
Fig. 2(b) Rear Panel for All
Other 3500 Series Models
Fig. 3 Panel Mounting
A
A
138 ± 1.0 mm
(5.43 ± 0.04 in)
68 ± 0.7 mm
(2.68 ± 0.03 in)
CLAMP SLIDE
CLAMP
SCREW