Danfoss VLT Automation Drive FC 360, Programming Manual

Page: 68 / 156

6-91 Terminal 42 Analog Output
Option: Function:
[105] Torq relate to rated
[106] Power
[107] Speed
[111] Speed Feedback
[113] Ext. Closed Loop 1
[139] Bus Control
[143] Ext. CL 1
[162] Tapered tension set point
[254] DC Link Voltage
6-92 Terminal 42 Digital Output
Option: Function:
[0]
*
No operation
[1] Control Ready
[2] Drive ready
[3] Drive rdy/rem ctrl
[4] Stand-by / no warning
[5] Running
[6] Running / no warning
[7] Run in range/no warn
[8] Run on ref/no warn
[9] Alarm
[10] Alarm or warning
[11] At torque limit
[12] Out of current range
[13] Below current, low
[14] Above current, high
[15] Out of frequency
range
[16] Below frequency, low
[17] Above frequency, high
[18] Out of feedb. range
[19] Below feedback, low
[20] Above feedback, high
[21] Thermal warning
[22] Ready, no thermal
warning
[23] Remote,ready,no TW
[24] Ready, no over-/ under
voltage
[25] Reverse
[26] Bus OK
[27] Torque limit & stop
[28] Brake, no brake
warning
[29] Brake ready, no fault
[30] Brake fault (IGBT)
[31] Relay 123
[32] Mech brake ctrl
[36] Control word bit 11
[37] Control word bit 12
[40] Out of ref range
6-92 Terminal 42 Digital Output
Option: Function:
[41] Below reference, low
[42] Above ref, high
[45] Bus ctrl.
[46] Bus control, timeout:
On
[47] Bus control, timeout:
Off
[56] Heat sink cleaning
warning, high
[60] Comparator 0
[61] Comparator 1
[62] Comparator 2
[63] Comparator 3
[64] Comparator 4
[65] Comparator 5
[70] Logic rule 0
[71] Logic rule 1
[72] Logic rule 2
[73] Logic rule 3
[74] Logic rule 4
[75] Logic rule 5
[80] SL digital output A
[81] SL digital output B
[82] SL digital output C
[83] SL digital output D
[160] No alarm
[161] Running reverse
[165] Local ref active
[166] Remote ref active
[167] Start command activ
[168] Drive in hand mode
[169] Drive in auto mode
[170] Homing Completed
The homing operation is
completed. This option is only
effective when
parameter 37-00 Application Mode
is set to
[2] Position Control
.
[171] Target Position
Reached
The target position is reached.
This option is only effective when
parameter 37-00 Application Mode
is set to [2] Position Control .
[172] Position Control Fault A fault occurred in the positioning
process. Refer to
parameter 37-18 Pos. Ctrl Fault
Reason
for details about the fault.
This option is only effective when
parameter 37-00 Application Mode
is set to [2] Position Control .
[173] Position Mech Brake Selects mechanical control for
positioning. This option is only
effective when
Parameter Descriptions
VLT
®
AutomationDrive FC 360
66 Danfoss A/S © 7/2015 All rights reserved. MG06C602
4 4