Danfoss VLT Automation Drive FC 360, Programming Manual

Page: 145 / 156

Par. No. # Parameter description Default value 2-set-up Change during
operation
Conversion
index
Type
37-43 Diameter Calculator Min Speed 0% 1 set-up TRUE 0 Uint16
37-44 Line Acceleration Feed Forward 0 N/A 1 set-up TRUE -3 Int16
37-45 Line Speed Source [0] No function 1 set-up FALSE – Uint8
37-46 Winder Speed Match Scale 1 N/A 1 set-up FALSE -3 Uint32
37-47 Tension PID Profile 0% 1 set-up TRUE -2 Uint16
37-48 Tension PID Proportional Gain 0 N/A 1 set-up TRUE -2 Uint16
37-49 Tension PID Derivate Time 0 s 1 set-up TRUE -2 Uint16
37-50 Tension PID Integral Time 501 s 1 set-up TRUE -2 Uint32
37-51 Tension PID Out Limit 0% 1 set-up TRUE -3 Uint32
37-52 Tension PID Der Gain Limit 5 N/A 1 set-up TRUE -1 Uint16
37-53 Tension PID Anti Windup [1] Enabled 1 set-up TRUE – Uint8
37-54 Winder Jog Reverse [0] No Function 1 set-up TRUE – Uint8
37-55 Winder Jog Forward [0] No function 1 set-up TRUE – Uint8
37-56 New Diameter Select [0] Core diameter 1 set-up FALSE – Uint8
37-57 Tension On/Off [0] Off 1 set-up TRUE – Uint8
37-58 Core Select [0] Core1 diameter 1 set-up FALSE – Uint8
37-59 Diameter Reset [0] Off 1 set-up FALSE – Uint8
Parameter Lists Programming Guide
MG06C602 Danfoss A/S © 7/2015 All rights reserved. 143
5 5