6-92 Terminal 42 Digital Output
Option:
Function:
parameter 37-00 Application Mode
is set to
[2] Position Control
.
[174] TLD indicator
Indicates whether the tension is
out of limit (
on
) during center
winding. This option is only
effective when
parameter 37-00 Application Mode
is set to
[1] Center winder
.
[175] Running on tension
Indicates whether tension PID
control is active (
on
) or inactive
(
off
). This option is only effective
when
is set to
[1] Center winder
.
[176] Ready to run
The center winder control is ready
to run. This option is only
effective when
parameter 37-00 Application Mode
is set to
[1] Center winder
.
[177] End of roll
The diameter limit is reached. This
option is only effective when
parameter 37-00 Application Mode
is set to
[1] Center winder
.
[193] Sleep Mode
The frequency converter/system
has entered sleep mode. See
parameter group
22-4* Sleep
Mode
.
[194] Broken Belt Function
A broken belt condition has been
detected. See parameter group
22-4* Sleep Mode
.
[198] Drive Bypass
6-93 Terminal 42 Output Min Scale
Range:
Function:
0 %
*
[0 -
200 %]
Scale for the minimum output (0 mA or 4 mA)
of the analog signal at terminal 42. Set the
value to be the percentage of the full range of
the variable selected in
6-94 Terminal 42 Output Max Scale
Range:
Function:
100
%
*
[0 -
200 %]
Scale for maximum output (20 mA) of the scaling
at terminal 42. Set the value to be the
percentage of the full range of the variable
selected in
parameter 6-91 Terminal 42 Analog
.
6-94 Terminal 42 Output Max Scale
Range:
Function:
(mA)
0%
20
0/4
100%
Current
Analogue
output
Min Scale
par. 6-93
Variable
for
output
example:
Power
Analogue
Output
Max Scale
par. 6-94
Illustration 4.19 Output Scale vs. Current
6-96 Terminal 42 Output Bus Control
Range:
Function:
0
*
[0 - 16384 ] Holds the analog output at terminal 42 if
controlled by bus.
Parameter Descriptions
Programming Guide
MG06C602
Danfoss A/S © 7/2015 All rights reserved.
67
4
4