xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
71
10
N
ETWORK
M
ONITORING
C
OMMANDS
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
show packet ports
<portlist>
show error ports
<portlist>
show utilization
[ports | cpu]
clear counters
{ports <portlist>}
clear log
show log
{index <value_list> }
clear attack_log
{[unit <unit_id 1-12> | all]}
show attack_log
{unit <unit_id 1-12>} {index <value_list>}
enable syslog
disable syslog
show syslog
create syslog host
<index 1-4> {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr> | state [enable | disable]}
config syslog host
[all | <index 1-4>] [severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr> | state [enable | disable]]
delete syslog host
[<index 1-4> | all]
show syslog host
{<index 1-4>}
config system_severity
[trap | log | all] [critical | warning | information]
show system_severity
config log_save_timing
[time_interval <min 1-65535> | on_demand | log_trigger]
show log_save_timing
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Used to display statistics about the packets sent and received by the Switch.
Syntax
show packet ports <portlist>
Description
This command is used to display statistics about packets sent and received by
ports specified in the
<portlist>
.
Parameters
<portlist>
−
Specifies a port or range of ports to be displayed. The beginning and
end of the port list range are separated by a dash.
Restrictions
None.
Example usage:
