D-Link xStack DGS-3600 Series, Cli Manual

Page: 304 / 431

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
301
41
DNS C
OMMANDS
The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
config dnsr [[primary | secondary] nameserver <ipaddr> | [add | delete] static
<domain_name 32> <ipaddr>]
enable dnsr {[cache | static]}
disable dnsr {[cache | static]}
show dnsr {static}
Each command is listed, in detail, in the following sections.
config dnsr
Purpose Used to configure the DNS relay function.
Syntax
config dnsr [[primary | secondary] nameserver <ipaddr> | [add |
delete] static <domain_name 32> <ipaddr>]
Description This command is used to configure the DNS relay function on the Switch.
Parameters
primary
−
Indicates that the IP address below is the address of the
primary DNS server.
secondary
−
Indicates that the IP address below is the address of the
secondary DNS server.
nameserver <ipaddr>
−
The IP address of the DNS nameserver.
[add | delete] – Indicates whether to add or delete the DNS relay
function.
<domain_name 32>
−
The domain name of the entry.
<ipaddr>
−
The IP address of the entry.
Restrictions Only administrator-level and operator-level users can issue this
command.
Example usage:
To set IP address 10.43.21.12 of primary.
DGS-3627:5#config dnsr primary 10.43.21.12
Command: config dnsr primary 10.43.21.12
Success
DGS-3627:5#
Example usage:
To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table:
DGS-3627:5#config dnsr add static dns1 10.43.21.12
Command: config dnsr add static dns1 10.43.21.12
Success.
DGS-3627:5#