xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
174
To delete a multicast VLAN called “accounting”:
DGS-3627:5#delete igmp_snooping multicast_vlan accounting
Command: delete igmp_snooping multicast_vlan accounting
Success.
DGS-3627:5#
show igmp_snooping multicast_vlan
Purpose
Used to display the settings of a multicast VLAN on the Switch.
Syntax
show igmp_snooping multicast_vlan {<vlan_name 32>}
Description
This command allows you to display the settings of a multicast VLAN on
the Switch.
Parameters
<vlan_name 32>
−
The name of the multicast VLAN to be displayed. This
name may be up to 32 characters in length.
Restrictions None.
Example usage:
To show a multicast VLAN:
DGS-3627:5#show igmp_snooping multicast_vlan accounting
Command: snow igmp_snooping multicast_vlan accounting
VID : 2 VLAN Name : accounting
Member Ports : 4-5
Source Ports : 6
Status : Enabled
Replace Source IP : 0.0.0.0
DGS-3627:5#
config igmp_snooping multicast_vlan_group
Purpose
Used to add or remove multicast addresses to or from a previously created
Multicast VLAN.
Syntax
config igmp_snooping multicast_vlan_group <vlan_name 32> [add
multicast_range <range_name 32> | delete multicast_range
[<range_name 32> | all]]
Description
This command allows users to configure the multicast group which will be
learned with the specific multicast VLAN.
Parameters
<vlan_name 32>
−
The name of the multicast VLAN for which IGMP
snooping is to be configured. This name may be up to 32 characters in
length.
add multicast_range <range_name 32> -
Use this parameter to add a
multicast address or list of multicast addresses to this multicast VLAN as
defined by a range. This range was created using the limited multicast
address commands.
delete multicast_range <range_name 32> -
Use this parameter to delete a
multicast address or list of multicast addresses to this multicast VLAN as
defined by a range. This range was created using the limited multicast
address commands.
all
- Enter this parameter to remove all multicast addresses range names
