xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
276
37
ARP
AND
G
RATUITOUS
ARP
C
OMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
create arpentry
<ipaddr> <macaddr>
delete arpentry
[<ipaddr> | all]
show arpentry
{ipif <ipif_name 12> | ipaddress <ipaddr> | static}
config arp_aging time
<value 0-65535>
clear arptable
config arpentry
<ipaddr> <macaddr>
config gratuitous_arp
send ipif_status_up
[enable|disable]
config gratuitous_arp
send
dup_ip_detected
[enable|disable]
config gratuitous_arp
learning
[enable|disable]
enable gratuitous_arp {ipif <ipif_name 12>} {trap |log }
disable
gratuitous_arp
{ipif <ipif_name 12>} {trap |log}
config gratuitous_arp
send periodically ipif
<ipif_name 12> interval <value 0-65535>
show gratuitous_arp
{ipif <ipif_name 12>}
Each command is listed, in detail, in the following sections.
create arpentry
Purpose
Used to make a static entry into the ARP table.
Syntax
create arpentry <ipaddr> <macaddr>
Description
This command is used to enter an IP address and the
corresponding MAC address into the Switch’s ARP table.
Parameters
<ipaddr>
−
The IP address of the end node or station.
<macaddr>
−
The MAC address corresponding to the IP address
above.
Restrictions Only
administrator-level
and operator-level users can issue this
command. The Switch supports up to 255 static ARP entries.
Example usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DGS-3627:5#create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DGS-3627:5#
