xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
298
Entering the Type combination
−
Internal, ExtType_1, ExtType_2
is functionally equivalent to
All
. Entering the combination
ExtType_1, ExtType_2
is functionally equivalent to
External
. Entering the combination
Internal, External
is functionally
equivalent to
All
.
Entering the metric 0
specifies transparency.
Example usage:
To add route redistribution settings
DGS-3627:5#create route redistribute dst rip src ospf all metric 2
Command: create route redistribute dst rip src ospf all metric 2
Success.
DGS-3627:5#
config route redistribute dst ospf src
Purpose
Used configure route redistribution settings for the exchange of RIP
routes to OSPF routes on the Switch.
Syntax
config route redistribute dst ospf src [static | rip | local] {mettype [1
| 2] | metric <value 0-16777214>}
Description
Route redistribution allows routers on the network
−
that are running
different routing protocols to exchange routing information. This is
accomplished by comparing the routes stored in the various router’s
routing tables and assigning appropriate metrics. This information is then
exchanged among the various routers according to the individual router’s
current routing protocol. The switch can redistribute routing information
between the OSPF and RIP routing protocols to all routers on the
network that are running OSPF or RIP. Routing information entered into
the Static Routing Table on the local switch is also redistributed.
Parameters
src [static | rip | local]
−
Allows the selection of the protocol of the source
device.
mettype
−
allows the selection of one of the methods for calculating the
metric value.
•
Type - 1 calculates the metric (for RIP to OSPF) by adding the
destination’s interface cost to the metric entered in the Metric field.
•
Type - 2 uses the metric entered in the Metric field without change.
This field applies only when the destination field is OSPF.
metric <value
0-16777214
>
−
Allows the entry of an OSPF interface cost.
This is analogous to a Hop Count in the RIP routing protocol.
Restrictions Only
administrator-level
and operator-level users can issue this
command.
Routing information source
−
RIP: the Static Route table, and the Local interface routing information. Routing information will be
redistributed to OSPF. The following table lists the allowed values for the routing metrics and the types (or forms) of the routing
information that will be redistributed.
Route Source
Metric
Metric Type
RIP
0 to 16777214
mettype 1
mettype 2
Static
0 to 16777214
mettype 1
mettype 2
Local
0 to 16777214
mettype 1
mettype 2
