xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
407
config lldp dot3_tlvs
that LLDP agent should transmit 'MAC/PHY configuration/status TLV'.
This type indicates it is possible for two ends of an IEEE 802.3 link to
be configured with different and/or speed settings and still establish
some limited network connectivity. More precisely, the information
includes whether the port support the auto-negotiation function,
whether the function is enabled, the auto-negotiated advertised
capability, and the operational MAU type. The default state is
disabled.
link_aggregation –
This TLV optional data type indicates that LLDP
agent should transmit 'Link Aggregation TLV'. This type indicates the
current link aggregation status of IEEE 802.3 MACs. More precisely,
the information should include whether the port is capable of doing
link aggregation, whether the port is aggregated in a aggregated link,
and the aggregated port ID. The default state is disabled.
power_via_mdi -
This TLV optional data type indicates that the LLDP
agent should transmit 'Power via MDI TLV'. Three IEEE 802.3 PMD
implementations (10BASE-T, 100BASE-TX, and 1000BASE-T) allow
power to be supplied over the link for connected non-powered
systems. The Power Via MDI TLV allows network management to
advertise and discover the MDI power support capabilities of the
sending IEEE 802.3 LAN station. The default state is disabled. Note:
Not supported in the current release.
maximum_frame_size
- This TLV optional data type indicates that
LLDP agent should transmit 'Maximum-frame-size TLV. The default
state is disabled.
Restrictions Only
administrator-level
and operator-level users can issue this
command.
Example usage:
To configure exclude the MAC/PHY configuration/status TLV from the outbound LLDP advertisements for all ports:
DGS-3627:5#config lldp ports all dot3_tlvs
mac_phy_configuration_status enable
Command: config lldp ports all dot3_tlvs
mac_phy_configuration_status enable
Success.
DGS-3627:5#
config lldp forward_message
Purpose
Used to configure the forwarding of LLDPDU packets when LLDP is
disabled.
Syntax
config lldp forward_message [enable | disable]
Description
When LLDP is disabled and LLDP forward_message is enabled, the
received LLDPDU packets will be forwarded. The default state is
disabled.
Parameters None.
Restrictions Only
administrator-level
and operator-level users can issue this
command.
Usage Example:
To configure LLDP forward_message:
