xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
400
config lldp tx_delay
Purpose
Used to change the minimum time (delay-interval) LLDP ports will
delay in advertising successive LLDP advertisements due to a change
in LLDP MIB content. The tx_delay defines the minimum interval
between sending of LLDP messages due to constantly change of MIB
content.
Syntax
config lldp tx_delay < sec 1–8192 >
Description
The LLDP message_tx_interval (transmit interval) must be greater
than or equal to (4 x tx_delay interval).
Parameters
tx_delay
- The range is from
1
second to
8192
seconds. The default
setting is
2
seconds. NOTE: txDelay should be less than or equal to
0.25 * msgTxInterval
Restrictions Only
administrator-level
and operator-level users can issue this
command.
Example usage:
To configure the delay interval:
DGS-3627:5#config lldp tx_delay 8
Command: config lldp tx_delay 8
Success.
DGS-3627:5#
config lldp reinit_delay
Purpose
Change the minimum time of the reinitialization delay interval.
Syntax
config lldp reinit_delay <sec 1 - 10>
Description
A re-enabled LLDP port will wait for reinit_delay after last disable
command before reinitializing.
Parameters
reinit_delay
– The range is from
1
second to
10
seconds. The default
setting is
2
seconds.
Restrictions Only
administrator-level
and operator-level users can issue this
command.
Example usage:
To changes the re-initialization delay interval to five seconds:
DGS-3627:5#config lldp reinit_delay 5
Command: config lldp reinit_delay 5
Success.
DGS-3627:5#
