xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
236
show traffic_segmentation
Purpose
Used to display the current traffic segmentation configuration on the Switch.
Syntax
show traffic_segmentation {<portlist>}
Description
This command is used to display the current traffic segmentation configuration on the
Switch.
Parameters
<portlist>
−
Specifies a port or range of ports for which the current traffic segmentation
configuration on the Switch will be displayed. The port list is specified by listing the
lowest switch number and the beginning port number on that switch, separated by a
colon. Then the highest switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3–2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 – in numerical order. Non–contiguous portlist entries are separated by a
comma. (ex: 1:1–1:3,1:7–1:9)
Restrictions None.
Example usage:
To display the current traffic segmentation configuration on the Switch.
D G S – 3 4 2 6 : 5 # s h o w t r a f f i c _ s e g m e n t a t i o n
C o m m a n d : s h o w t r a f f i c _ s e g m e n t a t i o n
T r a f f i c S e g m e n t a t i o n T a b l e
P o r t F o r w a r d P o r t l i s t
– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
1 : 1 1 : 1 – 1 : 2 4
1 : 2 1 : 1 – 1 : 2 4
1 : 3 1 : 1 – 1 : 2 4
1 : 4 1 : 1 – 1 : 2 4
1 : 5 1 : 1 – 1 : 2 4
1 : 6 1 : 1 – 1 : 2 4
1 : 7 1 : 1 – 1 : 2 4
1 : 8 1 : 1 – 1 : 2 4
1 : 9 1 : 1 – 1 : 2 4
1 : 1 0 1 : 1 – 1 : 2 4
1 : 1 1 1 : 1 – 1 : 2 4
1 : 1 2 1 : 1 – 1 : 2 4
1 : 1 3 1 : 1 – 1 : 2 4
1 : 1 4 1 : 1 – 1 : 2 4
1 : 1 5 1 : 1 – 1 : 2 4
1 : 1 6 1 : 1 – 1 : 2 4
1 : 1 7 1 : 1 – 1 : 2 4
1 : 1 8 1 : 1 – 1 : 2 4
C T R L + C
E S C
q
Q u i t
S P A C E
n
N e x t P a g e
E N T E R
N e x t E n t r y
a
A l l
