xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
130
17
ISM
VLAN
C
OMMANDS
The ISM VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create igmp_snooping multicast_vlan
<vlan_name 32> <vlanid 2–4094>
delete igmp_snooping mutlticast_vlan <vlan_name 32>
config igmp_snooping multicast_vlan
<vlan_name 32> {member_port <portlist> | source_port <portlist>
tag_member_port <portlist>| state [enable|disable] |replace_source_ip
<ipaddr>} (1)
config igmp_snooping
multicast_vlan_group
<vlan_name 32> [[add | delete] <mcast_address_list> | delete_all]
show igmp_snooping multicast_vlan
{<vlan_name 32>}
show igmp_snooping
multicast_vlan_group
{<vlan_name 32>}
Each command is listed, in detail, in the following sections.
create igmp_snooping multicast_vlan
Purpose
Used to create an ISM VLAN on the switch.
Syntax
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2–4094>
Description
This command is used to create a multicast VLAN on the Switch.
Parameters
<vlan_name 32>
– Specifies the ISM VLAN name, max length is 32
<vlanid 2-4094>
– Specifies the ISM VLAN ID.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To create an igmp_snooping multicast_vlan:
D G S – 3 4 2 6 : 5 # c r e a t e i g m p _ s n o o p i n g m u l t i c a s t _ v l a n t e s t 2
C o m m a n d : c r e a t e i g m p _ s n o o p i n g m u l t i c a s t _ v l a n t e s t 2
S u c c e s s .
D G S – 3 4 2 6 : 5 #
delete igmp_snooping multicast_vlan
Purpose
Used to delete a previously created ISM VLAN on the Switch.
Syntax
delete igmp_snooping multicast_vlan <vlan_name 32>
Description
This command is used to delete a previously created multicast VLAN on the Switch.
Parameters
<vlan_name 32>
– Specifies the ISM VLAN name, max length is 32.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To delete an ISM VLAN
