xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
452
61
M
ULTICAST
VLAN
R
EPLICATION
C
OMMANDS
The Multicast VLAN Replication commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
enable ipmc_vlan_replication
disable ipmc_vlan_replication
config ipmc_vlan_replication
{ttl [decrese | no_decrease] | src_mac [replace | no_replace]} (1)
create ipmc_vlan_replication_entry
<name 16>
config ipmc_vlan_replication_entry
source
<name 16> [[vlan <vlan_name 32> | vlanid <vlanid 1-4094>] | group [add |
delete] [mcast_ip <mcast_address_list>| mcast_ipv6
<mcastv6_address_list>]{[source_ip<ipaddr>|source_ipv6 <ip6addr>]}]
config ipmc_vlan_replication_entry
destination
<name 16> [add | delete] [vlan <vlan_name 32> | vlanid <vidlist>] ports
<portlist>
delete ipmc_vlan_replication_entry
{<name 16>}
show ipmc_vlan_replication
show ipmc_vlan_replication_entry
{<name 16>}
Each command is listed, in detail, in the following sections.
enable ipmc_vlan_replication
Purpose
Used to enable static IP multicast VLAN replication on the Switch.
Syntax
enable ipmc_vlan_replication
Description
This command is used to enable static IP multicast VLAN replication on the Switch. The
replication function is enabled by default.
Parameters None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To enable static IP multicast VLAN replication:
D G S - 3 4 2 6 : 5 # e n a b l e i p m c _ v l a n _ r e p l i c a t i o n
C o m m a n d : e n a b l e i p m c _ v l a n _ r e p l i c a t i o n
S u c c e s s .
D G S - 3 4 2 6 : 5 #
disable ipmc_vlan_replication
Purpose
Used to disable the static IP multicast VLAN replication on the Switch.
Syntax
disable ipmc_vlan_replication
Description
This command is used to disable the static IP multicast VLAN replication on the switch.
Parameters None.
Restrictions
Only Administrator and Operator-level users can issue this command.