xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
194
config 802.1x reauth
Purpose
Used to configure the 802.1X re–authentication feature of the Switch.
Syntax
config 802.1x reauth {port_based ports [<portlist> | all] | mac_based [ports]
[<portlist> | all] {mac_address <macaddr>}]
Description
This command is used to re–authenticate a previously authenticated device based on
port number.
Parameters
port_based
– This instructs the Switch to re–authorize 802.1X functions based only on
the port number. Ports approved for re–authorization can then be specified.
mac_based
−
This instructs the Switch to re–authorize 802.1X functions based only on
the MAC address. MAC addresses approved for re–authorization can then be specified.
ports <portlist>
−
Specifies a port or range of ports to be re–authorized. The port list is
specified by listing the lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch number, and the highest port
number of the range (also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3 specifies switch number 1,
port 3. 2:4 specifies switch number 2, port 4. 1:3–2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4
−
in numerical order.
all
−
Specifies all of the ports on the Switch.
mac_address <macaddr>
– Enter the MAC address to be re–authorized.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure 802.1X reauthentication for ports 1:1–1:18:
D G S – 3 4 2 6 : 5 # c o n f i g 8 0 2 . 1 x r e a u t h p o r t _ b a s e d p o r t s 1 : 1 – 1 : 1 8
C o m m a n d : c o n f i g 8 0 2 . 1 x r e a u t h p o r t _ b a s e d p o r t s 1 : 1 – 1 : 1 8
S u c c e s s .
D G S – 3 4 2 6 : 5 #
