D-Link TM DES-6500, Manual

Page: 173 / 352

DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
172
Figure 6- 135. OSPF Area Aggregation Settings table
Use the menu below to change settings or add a new OSPF Area Aggregation setting.
Figure 6- 136. OSPF Area Aggregation Settings – Add window
Specify the OSPF aggregation settings and click the Apply button to add or change the settings. The new settings will
appear listed in the OSPF Area Aggregation Settings table. To view the table, click the Show All OSPF Aggregation
Entries link to return to the previous window.
Use the following parameters to configure the following settings for OSPF Area Aggregation :
Parameter Description
Area ID Allows the entry the OSPF Area ID for which the routing information will be
aggregated. This Area ID must be previously defined on the Switch.
Network Number Sometimes called the Network Address. The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to the OSPF Area
above.
Network Mask The corresponding network mask for the Network Number specified above.
LSDB Type Specifies the type of address aggregation, which is set at Summary .
Advertisement Select Enabled or Disabled to determine whether the selected OSPF Area will
advertise it’s summary LSDB (Network-Number and Network-Mask).
Click Apply to implement changes made.