D-Link TM DES-6500, Manual

Page: 117 / 352

DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
116
Figure 6- 75. CPU Interface Filtering Rule Configuration – Ethernet
To set the Access Rule for Ethernet, adjust the following parameters and click Apply .
Parameters Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Access ID Type in a unique identifier number for this access and priority. This value can be set
from 1 - 100.
Type Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
•
Ethernet instructs the Switch to examine the layer 2 part of each packet
header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
VLAN Name Allows the entry of a name for a previously configured VLAN.
Source MAC Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC Destination MAC Address - Enter a MAC Address mask for the destination MAC
address.
Ethernet Type Specifies that the access profile will apply only to packets with this hexadecimal
802.1Q Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type
value may be set in the form: hex 0x0-0xffff, which means the user may choose any
combination of letters and numbers ranging from a-f and from 0-9999.
To view the settings of a previously correctly configured rule, click in the Access Rule Table to view the following
screen: