D-Link TM DES-6500, Manual

Page: 144 / 352

DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
143
Static/Default Route Settings
Entries into the Switch’s forwarding table can be made using both MAC addresses and IP addresses. Static IP forwarding
is accomplished by the entry of an IP address into the Switch’s
Static IP Routing Table . To view the following window,
click Configuration > Layer 3 IP Networking > Static/Default Route .
Figure 6- 106. Static/Default Route Settings window
This window shows the following values:
Parameter Description
IP Address The IP address of the Static/Default Route.
Subnet Mask The corresponding Subnet Mask of the IP address entered into the table.
Gateway The corresponding Gateway of the IP address entered into the table.
Hops Represents the metric value of the IP interface entered into the table. This field may
read a number between 1-65535 for an OSPF setting, and 1-16 for a RIP setting.
Protocol Represents the protocol used for the Routing Table entry of the IP interface. This field
may read OSPF, RIP, Static or Local.
Backup State Represents the Backup state that this IP interface is configured for. This field may read
Primary or Backup.
Delete
Click the if you would like to delete this entry from the Static/Default Route
Settings table.
To enter an IP Interface into the Switch’s Static/Default Route Settings window, click the Add button, revealing the
following window to configure.
Figure 6- 107. Static/Default Route Settings – Add window