D-Link TM DES-6500, Manual

Page: 107 / 352

DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
106
Figure 6- 63. Access Rule Configuration window - Ethernet.
To set the Access Rule for Ethernet, adjust the following parameters and click Apply .
Parameters Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Access ID Type in a unique identifier number for this access. This value can be set from 1 - 100.
Type
Selected profile based on Ethernet (MAC Address), IP address or Packet Content
Mask.
•
Ethernet instructs the Switch to examine the layer 2 part of each packet
header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
Priority (0-7)
This parameter is specified if you want to re-write the 802.1p default priority previously
set in the Switch, which is used to determine the CoS queue to which packets are
forwarded to. Once this field is specified, packets accepted by the Switch that match
this priority are forwarded to the CoS queue specified previously by the user.
replace priority
−
Click the corresponding box if you want to re-write the 802.1p
default priority of a packet to the value entered in the Priority field, which meets the
criteria specified previously in this command, before forwarding it on to the specified
CoS queue. Otherwise, a packet will have its incoming 802.1p user priority re-written
to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see
the
QoS section of this manual.
VLAN Name Allows the entry of a name for a previously configured VLAN.