DGS-3312SR Stackable Gigabit Layer 3 Switch
38
Switch Information
The first page displayed upon logging in is the
System Information (Basic Settings)
window. This window can be
accessed at any time by clicking the
Switch Information
link in the
Configuration
folder.
Figure 4- 1. Switch Information (Basic Settings) window
This window displays general information about the Switch including its MAC Address, Hardware Boot PROM and
Firmware versions, and installed module information.
IP Address
Switch IP settings may initially be set using the console interface prior to connecting to it through the Ethernet. If the
Switch IP address has not yet been changed, read the Introduction of the CLI Reference or skip ahead to the end of this
section for a quick description of how to use the console port and CLI IP settings commands to establish IP settings for the
Switch.
To change IP settings using the web manager you must access the
Switch IP Settings
window located in the
Configuration
folder.
To configure the Switch’s IP address:
Open the
Configuration
folder and click the
IP Address
link. The web manager will display the
Switch IP Settings
window below:
Figure 4- 2. Switch IP Settings window
