DGS-3312SR Stackable Gigabit Layer 3 Switch
119
Static/Default Route Settings
Static routes that have been previously configured appear in the Static/Default Route Settings table. To add a new route,
click on the
Add
button, a new window appears. To remove an existing route, click the
X
button in the Delete column for
the route you want to eliminate. To modify an existing entry, click the
Modify
button in the
Static/Default Route Settings
window, which will bring up the identical window as the
Add
window.
Figure 5- 8. Static/Default Route Settings window
Use the
Static/Default Route Settings – Add
window to configure IP settings and Metric cost for the new route.
Figure 5- 9. Static/Default Route Settings – Add window
Configure the IP settings for the new static route and click the
Apply
button to create the static route. The new route will
appear in the previous window. To view the new route and any other static routes configured for the Switch click the
Show
All Static/Default Route Entries
link.
The following fields can be set or viewed for windows of the Static/Default route Settings section:
Parameter Description
IP Address
The IP address of the Static/Default Route.
Subnet Mask
The corresponding Subnet Mask of the IP address entered into the table.
Gateway
The corresponding Gateway of the IP address entered into the table.
Hops/Cost
Represents the metric value of the IP interface entered into the table. This field may
read a number between 1-65535 for an OSPF setting, and 1-16 for a RIP setting.
Protocol
Represents the protocol used for the Routing Table entry of the IP interface. This field
may read OSPF, RIP, Static or Local.
Backup State
Represents the Backup state that this IP interface is configured for. This field may read
Primary or Backup.
Delete
Click the
X
if you would like to delete this entry from the Static/Default Route Settings
table.
