Apex PDT Technical Reference Manual
4 BIOS
COAM30002
Rev. 2.00
8/13/02
4-15
O
1
2
3
4
Switch
(white)
End Of Main Board
N
Figure 4-11: Apex PDT DIP Switch Configuration
5.
Place the BIOS Upgrade Flash Card into the Slot 0 (top)
card slot with the label side down (see Figure 4-12). When
properly installed and fully seated, the card ejection button
will be out.
INSERT
CARD
LABEL
SIDE
DOWN
SLOT
SLOT
"0"
"1"
CARD EJECTION
BUTTONS
Figure 4-12: Apex PDT Card Slot Configuration
6.
Power-up the unit. The Apex PDT will automatically begin
booting from the installed BIOS Upgrade Flash card (now
seen as A: Drive). After a few seconds the following
message will appear:
miniCMD>a:\crd2flsh
Card To Flash Vx.xx
This program will overwrite
the BIOS and boot disk with
the one contained on this card
at address 00000
Continue y/n [y]?
7.
To continue with the BIOS upgrade press the <ENT> key.
To stop the upgrade process first press the <N> key, then the
<ENT> key.
Summary of Contents for Apex III
