Apex PDT Technical Reference Manual
8 Using PC Cards
COAM30002
Rev. 2.00
8/13/02
8-1
8
USING PC CARDS
Introduction
The Apex PDT can accept up to two PC Cards (either two Type I or
II, or one Type III) for various purposes including network interface
adapters, high speed modems, flash drives, RAM disks, or audio
capabilities.
PC Card installation is accomplished by removing the Apex PDT
End Cap, than installing the card with the pins inward and the label
side down. Note that hardware configuration requirements demand
that Slot 0 (top) be filled to use Slot 1 (bottom). Refer to the BIOS
Upgrade section for End Cap removal details.
INSERT
CARD
LABEL
SIDE
DOWN
SLOT
SLOT
"0"
"1"
Figure 8-1: PC Card Installation
PC Card Interface
The Apex PDT utilizes the Phoenix PicoCard
interface. The
Phoenix PicoCard
includes the following functionality:
q
Socket Services
q
Card Services
q
Super Client Driver
The features provide support for both ATA and flash devices. The
Card and Socket Service features also provide "hot-swapping" and
the ability to use up to two PC Cards.
Summary of Contents for Apex III
