UNITIZED TRANSAXLE
Unitized Transaxle Installation
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 16-37
16
21. Connect the engine kill switch wire (18 gauge white/black) to the bullet connector at the lower right front
of the engine (Figure 16-93, Page 16-38).
22. Install three wire ties to secure the engine kill wire to the accelerator cable where they both route
together on the passenger side of the engine.
23. Connect the oil level sensor wire (18 gauge yellow) to the jumper wire (Figure 16-94, Page 16-39).
Figure 16-88 Driven Clutch
Figure 16-89 Snubber
Figure 16-90 Leaf Springs
Figure 16-91 Leaf Springs and Shackles
Install key onto input shaft.
Club Car
SNUBBER
BRACKET
SNUBBER
Roll powertrain under vehicle, then
lift snubber into the snubber bracket.
ClubCar
ClubCar
Lower vehicle to
approximately its
normal height...
Install bolts,
washers, and nuts.
Tighten to 15 ft.lb.
Then insert leaf spring into
front spring mount on each
side of the vehicle...
LEAF SPRING
ClubCar
ClubCar
Continue using
floorjack to lower
(or raise) vehicle in
order to align the
rear shackles and
leaf springs before
installing bolts,
washers, and nuts.
