ELECTRICAL COMPONENTS
Reverse Buzzer Limit Switch
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 12-21
12
REVERSE BUZZER LIMIT SWITCH
Read DANGER and WARNING on page 12-1.
Testing the Reverse Buzzer Limit Switch
See Test Procedure 19, Section 11, Page 11-37.
Reverse Buzzer Limit Switch Removal
1. Disconnect the battery cables, negative cable (–) first (Figure 12-1, Page 12-2).
2. Disconnect the wires from the reverse buzzer limit switch (4) located on the back of the Forward/
Reverse assembly (Figure 12-19, Page 12-18).
3. Remove the nuts (2) and washers (6) from the lockout cam limit switch (5) and slide the lockout cam
limit switch off of the screws. Do not disconnect the wires.
4. Remove the spacers (9) from the reverse buzzer limit switch (4) and slide the reverse buzzer limit
switch off the screws.
Reverse Buzzer Limit Switch Installation
1. Install the reverse buzzer limit switch (4), and then install two spacers (9) against the limit switch.
2. Install the lockout cam limit switch (5) with two washers (6) and two nuts (2). Tighten to 5 in-lb (0.6
N·m). See following CAUTION.
∆ CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, limit switches could be damaged.
3. Place the Forward/Reverse handle in REVERSE and make sure that only the reverse buzzer limit
switch is actuated.
4. Connect the orange wire to the common (COM) terminal and the red/white wire to the normally open
(NO) terminal of the reverse buzzer limit switch (4) (Figure 12-19, Page 12-18).
5. Connect battery cables, positive cable first and tighten the terminals to 20 ft-lb (27.1 N·m). Coat termi-
nals with Battery Protector Spray (CCI 1014305).
6. Turn the key switch to the ON position. Shift the Forward/Reverse handle to the REVERSE position.
The buzzer should sound.
OIL WARNING LIGHT
Read DANGER and WARNING on page 12-1.
Testing the Oil Warning Light
