en03d141.fm, 11.03.2008
PL12EN-1300 2008-03
67
Programming
3
insertion in the table. New entries are always inserted at the END of the table. Pressing the <F2>
“Delete” key brings up a dialog box in which the user types the table entry number to be deleted.
The delete function may be aborted by selecting “Cancel”. Pressing the <F3> “Part ID” key
returns the user to the Part ID configuration screen.
Note:
When the table is scanned for a Part ID Position/Value pair match, the scanning is termi-
nated after the first match in the table has been found. The Part ID character positions are
numbered from left to right.
Position
1-<Number of Characters>
Value
Any Alphanumeric character
Function
Use Application X, Use Tightening Group X, Tool Enable,
Tool Disable
App/Group
1-255 when function "Use Application X" is selected
1-8
when function "Use Tightening Group X" is selected
Ignored when function "Tool Enable" or "Tool Disable" is
selected
comprtid.txtE
3.7.3
Communications / Printer
c0
02
91e
n.b
m
p
Fig. 3-28: Printer
commprin.txtS
From this screen the user can configure the setup for the Parameter/Rundown Printer. When
Parallel Enable is checked, rundown data is automatically sent to the parallel port whenever a full
page has been queued. Unprinted rundowns are sent to the printer whenever any other print
request is made (typically by pressing Print <F1> from the Run Screen). The Filter parameter
allows the user to select whether All, OK, or NOK rundowns are printed. This filter applies to both
the automated printing of rundowns (Parallel Enable), and the manual printing of rundowns
(pressing Print <F1> from the run screen). Only the Centronics printer interface is supported. The
Font Size selection can be used to adjust the size of the printed output.
Note:
The Printer must be on before you switch on your TME. This will guarantee correct initialization
of the printer.
commprin.txtE