48
PL12EN-1300 2008-03
en03d141.fm, 11.03.2008
Programming
3
Tool Enable from Socket
Tray
Output data will include the tool enable signal from socket
tray
Tool Running
Output data will indicate when tool is in a rundown cycle
Tool Reverse
Output data will indicate when tool is in reverse
Cycle Complete
Output data will indicate when rundown cycle is complete
Tool Ready Input Pass-
Through
Output data will include the tool ready signal from the input
Green Tool Light
(Cycle OK)
Output data will indicate when cycle is within programmed
limits
Cycle NOK
Output data will indicate when cycle is outside of programmed
limits
Yellow Tool Light
Output data will indicate when cycle met the yellow light con-
ditions
Torque/Angle Results
Output data will indicate results for the torque and angle spe-
cifically
Appl. Select (9-255)
Output data will include current Application selection 1 to 255.
This can only be enabled if Application Select (1-8) is set
Socket Tray Appl.
Select (1-8)
Output data will indicate the socket tray appl. select
Fault
Indicates the servo module has detected an error (transducer,
resolver etc)