Cisco 5505 - ASA Firewall Edition Bundle, Cli Configuration Manual, Page: 420 / 2164

1-16
Cisco ASA Series CLI Configuration Guide
Chapter 1 Starting Interface Configuration (ASA 5510 and Higher)
Starting Interface Configuration (ASA 5510 and Higher)
security-level 100
ip address 10.1.1.5 255.255.255.0
no shutdown
!
interface Management0/1
shutdown
no nameif
no security-level
no ip address
Step 5
Above each pasted command section, create your new logical interfaces by entering one of the following
commands:
•
interface redundant number [1-8]
•
interface port-channel channel_id [1-48]
For example:
...
interface port-channel 1
nameif outside
security-level 0
ip address 10.86.194.225 255.255.255.0
no shutdown
!
interface port-channel 2
nameif inside
security-level 100
ip address 192.168.1.3 255.255.255.0
no shutdown
!
interface port-channel 3
nameif mgmt
security-level 100
ip address 10.1.1.5 255.255.255.0
no shutdown
Step 6
Assign the physical interfaces to the new logical interfaces:
•
Redundant interface—Enter the following commands under the new interface redundant
command:
member-interface physical_interface1
member-interface physical_interface2
Where the physical interfaces are any two interfaces of the same type (either formerly in use or
unused). You cannot assign a Management interface to a redundant interface.
For example, to take advantage of existing cabling, you would continue to use the formerly in-use
interfaces in their old roles as part of the inside and outside redundant interfaces:
interface redundant 1
nameif outside
security-level 0
ip address 10.86.194.225 255.255.255.0
member-interface GigabitEthernet0/0
member-interface GigabitEthernet0/2
interface redundant 2
nameif inside
security-level 100
ip address 192.168.1.3 255.255.255.0
member-interface GigabitEthernet0/1