Cisco 5505 - ASA Firewall Edition Bundle, Cli Configuration Manual

Page: 1503 / 2164

1-27
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the ASA IPS Module
Feature History for the ASA IPS module
AIP SSC for the ASA 5505 8.2(1) We introduced support for the AIP SSC for the ASA 5505.
The following commands were introduced:
allow-ssc-mgmt , hw-module module ip , and hw-module
module allow-ip .
Support for the ASA IPS SSP-10, -20, -40, and -60
for the ASA 5585-X
8.2(5)/
8.4(2) We introduced support for the ASA IPS SSP-10, -20, -40,
and -60 for the ASA 5585-X. You can only install the ASA
IPS SSP with a matching-level SSP; for example, SSP-10
and ASA IPS SSP-10.
Note
The ASA 5585-X is not supported in Version 8.3.
Support for Dual SSPs for SSP-40 and SSP-60 8.4(2) For SSP-40 and SSP-60, you can use two SSPs of the same
level in the same chassis. Mixed-level SSPs are not
supported (for example, an SSP-40 with an SSP-60 is not
supported). Each SSP acts as an independent device, with
separate configurations and management. You can use the
two SSPs as a failover pair if desired.
Note
When using two SSPs in the chassis, VPN is not
supported; note, however, that VPN has not been
disabled.
We modified the following commands: show module , show
inventory , show environment .
Support for the ASA IPS SSP for the ASA
5512-X through ASA 5555-X 8.6(1) We introduced support for the ASA IPS SSP software
module for the ASA 5512-X, ASA 5515-X, ASA 5525-X,
ASA 5545-X, and ASA 5555-X.
We introduced or modified the following commands:
session , show module , sw-module .
Table 1-2 Feature History for the ASA IPS module (continued)
Feature Name
Platform
Releases
Feature Information