Chicco 08079159510000, Instructions Manual

Page: 25 / 176

25 24
sides (Fig. 41).
3. Grasping both elastics, remove this section of
the fabric cover from the lap belt loops (F) on
both sides (Fig. 42).
4. The central protection is fastened to the
backrest by two toothed fixtures, pull the
central protection upwards, releasing the
toothed fixtures from their seats (Fig. 43).
5. Pull the cover up over the armrests and remove.
6. Now finish the removal process by pulling
the triangular plastic reinforcement, fitted
around the reclining adjuster button (H), up-
wards (Fig. 44A and 44B).
TO REPLACE THE COVER ON THE FRAME:
Straighten the backrest upright and widen the
side flaps.
SEAT
Start by covering the seat, repeating operations 6
to 1 in the reverse order, paying particular attention
that the cover fits over all parts of the frame per-
fectly, especially around the two lap belt guides (F)
threading the elastics under each of them.
BACKREST
Start from the headrest making sure you insert
the elastic and the section of the fabric in the
rear cover. Now fit the cover on, following the in-
structions for operations 1 and 2 in reverse order.
CLEANING AND MAINTENANCE OF THE
SEAT COVERS
The cleaning and maintenance operations
must only be carried out by an adult.
HOW TO CLEAN THE FABRIC COVER
The child car seat fabric cover is completely
removable and washable. Please refer to the
care label for instructions on cleaning the fab-
ric cover:
Machine washable at 30°C.
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Never use abrasive detergents or solvents.
Do not spin dry the fabric cover, let it dry with-
out wringing it.
The fabric cover must only be replaced with
another cover approved by the manufacturer,
since it is an integral part of the child car seat
and, therefore, one of its safety elements.
WARNING!
To ensure the safety of the child car
seat, never use it without its fabric cover.
CLEANING THE PLASTIC PARTS
Clean the plastic parts cloth dipped in water
or a neutral detergent. Never use abrasive de-
tergents or solvents. The movable parts of the
child car seat must not be lubricated.
CHECKING THE CONDITION OF THE COM-
PONENTS
It is recommended to regularly check the con-
dition of the following components to ensure
that they are not damaged or worn out:
• fabric cover: check that the padding does not
come out from the seams. Check the condi-
tion of the seams: they must always be intact
and undamaged.
• plastic parts: check that the plastic parts are
not worn out, damaged or faded.
WARNING!
If the child car seat is deformed or
worn out, it must be replaced: it may no longer
comply with the original safety standards.
STORING THE PRODUCT
When it is not fitted in the car, it is recommend-
ed to store the child car seat in a dry place,
away from sources of heat and to protect it
from dust, humidity and direct sunlight.
DISPOSING OF THE PRODUCT
When the child car seat no longer complies
with the original safety standards, stop using it
and dispose of it at an appropriate collection
point. Dispose of the product as laid down in
the environmental regulations in force in the
Country of use.
WARRANTY
The product is guaranteed against any con-
formity defect in normal conditions of use as
provided for by the instructions for use. The
warranty shall not therefore apply in the case
of damages caused by improper use, wear or
accidental events. For the duration of warranty
on conformity defects please refer to the spe-
cific provisions of national laws applicable in
the country of purchase, where provided.