Cantek KQ0824 Series, User Manual

Page: 100 / 215

100
7.4 Setup
7.4.1 Local Setup - Device

Please make sure the network setting of DVR has been done properly prior to the remote connection setting.
7.4.1.1 Remote Site Connection Setup

Click Setup
– Local Setup – Device to enter the setup and a dialog will pop up as below picture.
7.4.1.1.1. New Device Register
 Select “Device Connection List” on left-hand side and click [New] to register new devices.


Describe the connection information as below. User must fill in where information requested in bold .
-
Device Name : Type the DVR name to be displayed in the server list pane. Please note that this name has no relation to
the ID registered in DVR. Users may create a name to be easily distinguished.
-
Description: Type brief description of the site
-
IP Address : Input IP address or Domain Name of DVR (check from the SETUP>DEVICES>Network in DVR)
-
Command Port : I
nput Administrator’s number among port numbers set in DVR (check from the
SETUP>DEVICES>Network in DVR). Default port number is 5920
-
Stream Port : Input Video/Audio number among port numbers set in DVR (check from the SETUP>DEVICES>Network in
DVR). Default port number is 5921
-
Login ID : Type authorized ID of the DVR. Default ID is admin .
-
Login Password : Type correspond password of the ID. Default Password is 1111
-
Confirm Password : Retype the password to confirm
-
Pop up Display: User can setting either video pop up or beep on corresponding channel when event occurs.
Device