Canon iR C3380 series, Service Manual

Page: 583 / 610

Chapter 18
18-9
F-18-12
18.2.3 Making Connections (SST in use)
0014-4492
/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
[Requirements]
- PC to which the SST (version 3.22 or later) has been installed and the system software has been copied
- twisted-pair cross cable
10Base-T: Category 3 or 5
100Base-TX: Category 5
[Procedure]
1) Start up the PC.
2) Connect the PC to the machine with a cross cable.
3) Check the network settings of the PC.
3-1) Start the command prompt, and type in " IPCONFIG ," and press the Return key.
3-2) Check to be sure that the network settings appearing on the screen are as follows; if not, change the PC network settings:
IP address: 172.16.1.160
Subnet mask: 255.255.255.0
Default gateway: any
Do not use the following IP addresses:
- 172.16.1.0
- 172.16.1.100
- 172.16.1.255
4) Check to make sure that the Execute/Memory lamp on the control panel is off; then, turn off the main power switch.
4-1) Hold down the power switch on the control panel for 3 sec or more.
4-2) Go through the shut-down instructions appearing on the control panel screen so that the main power switch may be turned off.
4-3) Turn off the main power switch.
F-18-13
5) Set the machine to the appropriate mode:
- Normal Mode
Turn on the main power switch while holding down the keys 1 and 7.
When the machine has started, make the following selections in service mode:
COPIER > FUNCTION > SYSTEM > DOWNLOAD; then, click [OK].
- Safe Mode
Turn on the main power switch while holding down the keys 2 and 8. In response, the machine will start up in safe mode.
MFP
USB
Target Selection
CONTROL Export Firm Selection
iRC3380
MFP
USB
BOOT
BROWSER
DCON
MEAPCONT
SDICT
SYSTEM
LANGUAGE
RUI
iRC3380
d:
USenXXXX(US)
Y XXxxvXXXX
Y XXxxvXXXX
Y XXxxvXXXX
Y XXxxvXXXX
N XXxxvXXXX
N USenvXXXX
Y XXenvXXXX
N XXjavXXXX
Y XXenvXXXX
N XXjavXXXX
Valid drive
DriveType:1
FileSystem:FAT
TotalSize:1,001MB
FreeSpace:1,001MB
CANCEL
EXIT
O K
R e g i s t e r F i r m wa r e
E x p o r t F i r m wa r e
D e l e t e F i r m wa r e
D e l e t e B a ck u p D a t a
S y s t e m M a n a g e m e n t
S e l e c t t h e t a r g e t . C l i c k a b u t t o n t o exe c u t e .
F i l e c o py h a s b e e n c o m p l e t e d .
Series
Version
Firmware registration status
Service Support Tool DLM0 (Ver.3.22E)
IP address: 172.16.1.100
Subnet mask: 255.255.255.0
IP sddress: 172.16.1.160
Subnet mask: 255.255.255.0
Cross cable
10Base-T: category 3, 5 or later
100Base-TX: category 5 or later