Canon iR C3380 series, Service Manual

Page: 565 / 610

Chapter 17
17-81
17.7 TEST (Test Print Mode)
17.7.1 COPIER
17.7.1.1 COPIER Table
0014-6148
/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
1. PG
T-17-63
Type of test print for each number entered for PG > TYPE
T-17-64
COPIER>TEST>PG
Sub item Description level.
TYPE Performs test print when test print type number is entered and start key is turned ON. (This setting must always be
restored to 0 after making test print.)
Setting values
0: Normal print, 0 to 100
[Factory default/After RAM clear: 0]
1
TXPH Used to set image mode during test print output.
Setting value
0: Error diffusion
1: Screen with small line number [133 to 190 lines]
2: Screen with large line number [200 to 268 lines]
3: Screen for COPY [around 220 lines]
4: Screen for REOS [no screen structure]
5:Error diffusion[w/ end correction ]
6:Screen with large line number[w/ end correction]
[Factory default/After RAM clear: 0]
1
THRU Used to select whether to use image compensation table during test print output.
Setting values
0: ON (Use)
1: OFF (Don't use)
[Factory default/After RAM clear: 0]
1
DENS-Y/M/C/K Used to adjust density of each color for test prints (TYPE = 5).
Setting values
0 to 255: Increasing the value increases the density.
[Factory default/After RAM clear: 128]
1
COLOR-Y/M/C/K Used to set output of each color for each TYPE.
For example, to set single-color M output, set "COLOR-M = 1", and make the other settings 0 (only single colors can be
output).
Setting values
0: Don't output
1: Output
[Factory default/After RAM clear: 1]
1
F/M-SW Set it to switch over full color and mono color during PG output.
Settings
0: full color output
1: mono color output
[Factory default/After RAM clear: 0]
1
PG-PICK Used to select output level during test print output.
Setting values
1: Cassette 1
2: Cassette 2
3: Cassette 3
4: Cassette 4
5 to 6: Not used
7: Side deck
8: Manual feed
[Factory default/After RAM clear: 1]
1
2-SIDE Use it to set the output mode for test printing.
Settings
0: single-sided (at time of shipment/upon RAM initialization)
1: double-sided
[Factory default/After RAM clear: 0]
1
PG-QTY Use it to set the output mode for test printing.
Use it to set the copy count of test printing.
1 to 999
[Factory default/After RAM clear: 1]
1
Entered number Description
0 Image from CCD (normal print)
1 For development
2 For development
3 For development
4 16 gradations
5 Full-sheet half tones
6 Grid
7 For development