CANADIAN stove IDRO 20, Manual

Page: 63 / 447

7
EN
PARAMETER M. UNITS
XSAT200-DD-AU XSAT240-DD-AU
Heat input kW
20,1 24,0
Nominal heat output kW
19,2 22,8
Reduced heat output kW
6,5 7,9
Water heat output kW
17,4 20,9
Reduced water heat output kW
5,4 6,6
CO concentration at nominal reference (13% O
2
) mg/m
3
23 36
CO concentration at reduced reference (13% O
2
) mg/m 3
107 195
Nominal efficiency %
95,6 94,9
Reduced efficiency %
95,9 94,2
Pellet consumption (min-max) Kg/h
1,41 - 4,19 1,75 - 5,0
Heated surface mc
350 400
Flue gas flow rate (min-max) g/s
6,5 - 11,2 9,1 - 13,5
Draft (min-max) Pa
5 - 8 5 - 8
Flue gas temperature (min-max) °C
65 - 97 75 - 108
Thermostove water litri
50 50
Maximum working pressure Bar
3 3
Tank capacity Kg
42 42
Smoke outlet tube mm
80 80
Diameter air intake mm
50 50
Connecting heating Inch
3/4 3/4
Nominal voltage V
230 230
Nominal frequency Hz
50 50
Power consumption max W
320 345
Thermostove weight Kg
230 230
IEE
137 135
Ambiental decree n.186
Energetic class
A++ A++
Dust at 13% O
2
at nominal heat output mg/m
3 10 10
N° Test Report K 28602020 T1
It is recommended that the control of emissions after installation.
With obvious floor capacity evaluation, in the installation premises, a maximum can be deposited of
fuel, which corresponds to approx. 975kg of pellets.
In order to achieve the test report results, please load the performance parameters retained
by the manufacturer and the qualified tecnichian. They will use these parameters once
verified that, during the installation, it is possibile to reproduce the laboratory conditions.
This performance is only reached after 15/20 working hours at nominal power.