CANADIAN stove IDRO 20, Manual

Page: 62 / 447

6
EN
PARAMETER M. UNITS NSAT200 NSAT240
Heat input kW 19,03 23,12
Nominal heat output kW 18,22 21,96
Reduced heat output kW 5,08 5,08
Water heat output kW 13,98 17,86
Reduced water heat output kW 4,20 4,20
CO concentration at nominal reference (13% O
2
) mg/m
3
54,9 55,9
CO concentration at reduced reference (13% O
2
) mg/m 3 356,6 356,6
Nominal efficiency % 95,74 94,98
Reduced efficiency % 96,71 96,71
Pellet consumption (min-max) Kg/h 1,113 - 4,028 1,113 - 4,893
Heated surface mc 350 400
Flue gas flow rate (min-max) g/s 4,5 - 10,1 4,5 - 12,9
Draft (min-max) Pa 5 - 10 5 - 10
Flue gas temperature (min-max) °C 62,1 - 99,1 62,1 - 109,2
Thermostove water litri 50 50
DHW flow rate litres/minute 7,8 9,44
Maximum working pressure Bar 2,5 2,5
Tank capacity Kg 42 42
Smoke outlet tube mm 80 80
Diameter air intake mm 50 50
Connecting heating Inch 3/4 3/4
Connecting health Inch 1/2 1/2
Nominal voltage V 230 230
Nominal frequency Hz 50 50
Power consumption max W 400 400
Thermostove weight Kg 230 230
IEE 131 130
N° Test Report K 1324 2014 T1
Ambiental decree n.186
Energetic class
A ++
Dust at 13% O
2
at nominal heat output mg/m
3
8,9 8,5
It is recommended that the control of emissions after installation.
With obvious floor capacity evaluation, in the installation premises, a maximum can be deposited of
fuel, which corresponds to approx. 975kg of pellets.
In order to achieve the test report results, please load the performance parameters retained
by the manufacturer and the qualified tecnichian. They will use these parameters once
verified that, during the installation, it is possibile to reproduce the laboratory conditions.
This performance is only reached after 15/20 working hours at nominal power.