![CANADIAN stove IDRO 20 Manual Download Page 70](http://html1.mh-extra.com/html/canadian-stove/idro-20/html/canadian-stove/idro-20/idro-20_manual_3809939070.webp)
14
EN
Connect the stove using hoses so that the stove
is not too strictly connected to the system, and to
allow slight movement.
These are as helpful as the supply and return
piping system if the heating system is on a higher
floor than the stove.
The exhaust pipe pressure is connected temporarily
to a carafe or a funnel to avoid, in case of
overpressure, that the water gush bathrooms and
the structure and the floor.
A PLATE HEAT
EXCHANGER
The kit is preassembled by the manufacturer’s task
is to heat the domestic water from the water line
of the dwelling. In the moment in which there
is request for opening a hot water tap, the flow
switch commands the diverter valve to convey the
hot water contained inside of the thermostove
towards the plate heat exchanger.
In the case in which the heater is turned off and
there is demand for sanitary water, the heater
after 30 seconds from the request, it automatically
starts the ignition process to heat the water inside
the thermostove and then to heat the sanitary
water.
Directions for use
If the installation of the thermostove provides
interaction with another existing system complete
with a heater (gas thermostove, gas thermostove,
oil thermostove, etc..) consult qualified personnel
who can then answer the compliance of the
system, as envisaged by the law in force.
Flushing the system
In accordance with the UNI-CTI 8065 is strongly
recommended to wash the entire system before
connecting it in order to get rid of residues and
deposits.
After flushing the system to protect it against
corrosion and deposits, it is recommended the
use of inhibitors. Upstream from the stove, always
install shutters so as to disconnect it from the
plumbing system should it be necessary to move
it, or when it requires routine and/or special
maintenance.
Filling the thermostove funding of sanitary
kit
Once all the water connections, proceed to check
pressure seal by filling the thermostove. During
this operation, any air in the system is released
from the automatic vent valve.
VENTING
SAFETY
VALVE
VENTING
SAFETY
VALVE
Summary of Contents for IDRO 20
