69
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© 2001-2008 Calix. All Rights Reserved.
To install a controller module
1.
Unpack the controller module.
2.
If the face plate is attached to the controller module, disconnect its display cable from the
controller module.
3.
Insert the controller module halfway into the control slot on the Valere shelf.
4.
Connect signal cables to the controller module as follows:
a.
Connect the alarm (ALM), temperature probe (T3), and expansion (EXP) cables to
the controller module.
b.
Connect the face plate's display cable (Display) to the controller module. Allow the
face plate to dangle.
5.
Push firmly on the module to seat it in the slot, then tighten the set screw.
6.
Attach the face plate to the controller module.
To install a rectifier module
1.
Unpack the rectifier module.
2.
On the lower left of the module face plate, press the tab to release the ejector lever.
3.
Insert the rectifier module into an empty slot in the Valere shelf. Slots are typically
populated from left to right.
4.
Push firmly on the module to seat it in the slot.
5.
Push the ejector lever closed to secure the module in place.
6.
Repeat Steps 1–5 to install additional rectifier modules.
Refer to the
Valere Compact DC Power System Installation and Maintenance
manual for more
information.
