BYD L3 AUTO, Owner'S Manual

Page: 62 / 202

BYD L3
AUTO Owner’s Manual
1-54 Lighting, Wiper, Defroster
Illumination intensity sensor is located
on the top of driver’s instrument
panel.
Do not leave any objects within this
area or stick any object on the
windshield around this area to avoid
shutting light from the sensor.
If you open driver’s door when ignition
switch is on ―ACC", ―LOCK‖ or
removed and when headlight switch is
turned on, the headlights will go out
automatically. To turn on the light
again, turn the ignition switch to ―ON‖
and turn on the headlight switch. If the
car will be parked for over one week,
make sure headlight switch is turned
off.
NOTE
To prevent the battery from over
discharge, when the engine is not
running, do not keep lights on for
long time.
High/low beam
– to use high beam,
turn on the headlight and push the
handle outwards (position 1). To use
low beam, push the handle to yourself
(position 2).
The blue indicator for high beam
headlight
on the combination
instrument indicates that the
headlights are turned on.
High
Beam Headlight Flashing
(position 3)
– push the handle
backwards fully. When release the
handle, the headlight will be turned
off.
Turning the knob to ―OFF‖ can also
make the high beam headlights flash.
Turn Signal Lights
To give out turn signal, push the
headlight/turn signal light handle
upwards/downwards to position 1.
T
he ignition switch shall be on ―ON‖.
After the vehicle has finished turning,
the handle will reset to its original
position automatically; but in lane
changes, you must reset it manually.
To give out lane change signal, push
the handle upwards/downwards to
position 2 and hold there.
IF the green turn signal indicator on
the combination instrument flashes at