BYD L3 AUTO, Owner'S Manual

Page: 190 / 202

BYD L3
AUTO Owner’s Manual
7-24 Self-maintenance
Before Adding Cleanser
Pull out cleanser funnel and hang it
on the brake of engine hood support.
Water can be used as cleanser. But in
cold region where the temperature is
below zero degree, you shall use
cleanser with ant freezing agent. It is
available in BYD service stations and
most auto part stores. For mixing ratio
of water and anti-freezing agent,
please
refer to manufacturer’s
instructions.
Make sure put back the funnel in
place after filling full the cleanser tank.
NOTE
Don’t use engine antifreeze or
other substitutes, as they will
damage the vehicle paint.
Replace Bulb
The following figures shows the
method to take off the bulbs. Make
sure the ignition switch and light
switches are turned off when
replacing bulbs.
NOTE
Only use a bulb of the below
listed type.
Use bulbs with rated power shown in
the table below:
High mount brake light and rear brake
light consists of a number of LED.
When the number of burnt out LED
affects the car’s compliance with local
laws, please send the car to BYD
service station for replacing bulbs.
TIPS
● Do not replace bulb when it is
hot to avoid burning.
● The halogen bulb is filled with
pressurized gas, please be
particularly careful. If the bulb
is scratched or falls to ground,
it may explode or crack. Only
hold the bulb on its plastic or
metal part. Do not touch glass
part of the bulb with bare
hands.
When traveling in rain or when the
light shade is wet after washing, the
inside of lamp shade of external light
such as headlight will temporarily fog.
As with fog on the windshield in rainy
days, the fog inside the light shade is
due to the temperature difference
between the inside and the outside of
light shade, and isn’t a trouble. But if
there is water droplet or water pool in
the lightshade, please contact BYD
service station.