BYD L3 AUTO, Owner'S Manual

Page: 139 / 202

BYD L3
AUTO Owner’s Manual
Emergency Treatment 4-3
(c) Jump Start
To avoid personal injury and damage
to the car and electronic components
caused
by battery explosion,
sulphuric acid burning, electrical
appliances fire, please strictly follow
the instructions below.
If you are not sure about these
procedures, please contact BYD
service station for help.
TIPS
● The battery contains toxic and
erosive sulphuric acid. While
making jump start, please wear
safety glasses and protect your
skin, clothes, and the car from
being spilled with sulphuric
acid leakage.
● If sulphuric acid comes in
contact with any part of your
body or your eyes accidentally,
please take off the clothes
immediately, wash the afflicted
part with clean water, and go to
see the doctor quickly. If
possible, continue to clean the
affected area with sponge or
cloth soaked in water on the
way to the hospital.
● If there is flame or sparkle
nearby, the gas generated by
battery may cause explosion.
Please use standard wire for
jump start and avoid smoking
or lighting a match.
NOTE
The charging battery shall be 12V.
Before conducting a jump start,
please make sure the charging
battery is applicable.
Procedures of Jump Start
1. If the charging battery is installed
on another car, please make sure
there is no contact between two
cars. Shut down all unwanted
lights and electrical devices.
2. If necessary, remove all plugs for
opening of the charging battery
and depleted battery, and cover a
piece of cloth on the opening.
(This is helpful to reduce danger of
explosion, personal injury and
burning.)
3. Start and run the engine of the car
with charging battery for a few
minutes. Step lightly on the
accelerator pedal to keep the
engine running at 2000rpm.