BYD ATTO 3 2022, Owner'S Manual

Page: 143 / 201

142
• Tap on this button again to disable the
function.
• This function is not to be used to dry
raindrops or melt snow.
REMINDER
•Using the side mirror electric heating
defrosting function for a long time
may cause the mirror to wear out
faster. Turn off the defrost button
when it is not needed.
CAUTION!
•When cleaning the inside of the rear
window, be careful not to scratch
or damage the heating wire and the
connector.
Air amount regulation button Air amount regulation button
• A/C air amount regulation
• Tap on the chosen position, the higher
the position, the larger the air amount.
• Tap on to set it at position 1, and
tap to set it at position 7.
Blowing Mode button Blowing Mode button
• Tap on the corresponding icon on
the Infotainment system to select the
corresponding blowing mode.
• Air blowing modes can be combined
freely, and up to three air blowing
modes can be enabled simultaneously
as required.
• Adjustments can be made according to
the following air supply.
Usage Essentials
• To quickly cool down the interior after
long exposure to sunlight, drive for a
few minutes with the windows open
to exhaust hot air and speed up A/C
cooling.
• To speed up cooling, adjust the
temperature to "Lo" and select the
internal circulation mode for a few
minutes.
• Make sure that the air intake grille in
front of the windshield is not blocked.
• In humid weather, avoid blowing cool air
onto the windshield to prevent fogging
and reduced visibility.
• Keep the space under the front seats
clear to improve air circulation.
• In cold weather, set the air volume to a
high range for 1 minute to remove snow
or moisture from the intake passage and
reduce fogging.
• In cold weather, select internal
circulation for a few minutes for quick
heating. To prevent fogging after cabin is
heated, select external circulation for air
intake.
• Drivers should close all windows, set
internal circulation mode, and turn on
A/C fans when driving in dusty or windy
conditions.
• In heating mode, press the compressor
control button to light up the button
(turning on the compressor), which can
reduce airflow moisture.