BYD ATTO 3 2022, Owner'S Manual

Page: 110 / 201

109
USING AND DRIVING
05
• There is no vehicle network
communication failure prompt on the
dashboard.
• The auto emergency braking function is
not activated.
Cruise Button Operation
ACC on/off button ACC on/off button
Press the button (1) (when the activation
conditions are met, the system will be on
stand-by) to turn ACC on/off.
Increase target vehicle speed/ACC reset
Increase target vehicle speed/ACC reset
Push up the lever (2) to restore to the stored
speed prior to exiting the cruise system
last time. If no cruise speed is stored, the
vehicle travels at current speed.
Decrease target vehicle speed/vehicle Decrease target vehicle speed/vehicle
speed setting speed setting
• If the lever (2) is toggled, ACC will set the
current speed as the target speed when
it is activated from standby. If the current
speed is below 30 km/h or 20 mph, the
target speed will be set to 30 km/h or
20 mph; and if the current speed is
above 150 km/h or 95 mph, the target
speed will be set to 150 km/h or 95 mph.
• When the ACC function is active, vehicle
speed can be set within a 30~150 km/h
(20~95 mph) range, by toggling lever (2).
By toggling lever (2) up/down, tarhet
speed can be increased/decreased by
5 km/h(mph). When cruise is on standby
within the same ignition cycle, the
system memorizes the last speed setting.
ACC exit ACC exit
Pressing the brake pedal will make the ACC
system go on stand-by. Press the key (1)
again to deactivate the ACC function. A safe
vehicle distance must be selected.
Set vehicle distance
Set vehicle distance
• The driver shall select a safe vehicle
distance.
• This system adjusts vehicle speed to
keep a suitable distance from the vehicle
ahead on the same lane. Keys (3) and (4)
can be pressed to adjust the four vehicle
distance values. For each value, vehicle
distance is in direct proportion to vehicle
speed. The faster the speed, the longer
the distance.
Increase/decrease speed with ACC Increase/decrease speed with ACC
activated activated
• When ACC is activated, the accelerator
may be pressed so the set target cruise
speed is reached. The system will enter
over speed mode. If the vehicle is
already going at the target cruise speed
and the accelerator is pressed, the
vehicle will return to target speed after
the accelerator is released. If the lever (2)
is pulled down while accelerating, the
current speed will be reset as the target
cruise speed. If the speed goes above
150 km/h, or the accelerator is pressed
for over 15 minutes, the system will go
on stand-by and the ACC will need to be
reactivated.