BRP Ski-Doo 1200 4-TEC 2018, Operator'S Manual

Page: 95 / 211

BASIC PROCEDURES
WARNING
Make sure tether cord cap is re-
moved before standing in front the
vehicle, getting close to the track
or rear suspension components.
NOTE: On E-TEC models, warm-up is
electronically controlled. During this
period (up to 10 minutes depending on
ambient temperature), engine RPM is
limited.
Engaging Reverse (RER)
(E-TEC)
When the engine is running, depress-
ing the RER button will slow down en-
gine RPM to almost a stop and advance
the ignition timing to invert crankshaft
rotation.
– Engine will automatically shift into
forward when restarting after stop-
ping or stalling.
– Shifting procedure will take place
only when the engine is running.
– If engine is running at a speed above
4300 RPM, the function of the RER
button is disabled.
– It is recommended to warm up the
engine to its normal operating tem-
perature before shifting.
Shifting in Reverse
1. Bring vehicle to a complete stop.
2. Apply and hold brake.
Remain
seated, refer to
RIDER POSITION
(REVERSE OPERATION)
for pos-
ture information.
3. With engine at idle speed, press and
release the RER button.
4. Wait until reverse beeper sounds,
then gently depress throttle lever.
WARNING
Engaging the reverse mode is
done
by depressing the RER
button when the engine is run-
ning. Wait until the reverse alarm
sounds and the RER pilot lamp
comes on in the analog/digital
gauge before operating throttle
to proceed in reverse. The reverse
speed is not limited. Always pro-
ceed with caution as fast reverse
could result in loss of vehicle sta-
bility. Come to complete stop be-
fore depressing RER button. Al-
ways remain seated and apply the
brake before shifting. Ensure the
path behind is clear of obstacles or
bystanders before proceeding.
Shifting in Forward
1. Bring vehicle to a complete stop.
2. Apply and hold brake.
3. Press and release the RER button.
4. RER pilot lamp will stop.
5. Apply throttle slowly and evenly. Al-
low drive pulley to engage then ac-
celerate carefully.
Shifting in Reverse or
Forward (ACE and 1200
4-TEC)
WARNING
When shifting in reverse, wait un-
til the reverse alarm sounds and
the pilot lamp comes on in the
analog/digital gauge before oper-
ating throttle. The reverse speed is
not limited. Always proceed with
caution as fast reverse could result
in loss of vehicle stability. Come
to complete stop before depress-
ing engaging the reverse. Always
remain seated and apply the brake
before shifting. Ensure the path
behind is clear of obstacles or by-
standers before proceeding.
_______________
93