BRP Ski-Doo 1200 4-TEC 2018, Operator'S Manual

Page: 110 / 211

TUNE YOUR RIDE
3. Depress the heated throttle lever
switch as shown to increase or de-
crease air pressure.
mmo2014-004-002_b
TYPICAL
1. Heated throttle lever switch
2. Increase pressure
3. Decrease pressure
4. The desired set point appears on
the display. To confirm, press the
MODE (M) button or wait 5 sec-
onds.
mmo2009-005-040_a
1. Set point
2. Actual setting
Front Suspension
Adjustments
Skis (Expedition Sport)
On theses models, it is possible to set
the ski stance to two different width.
When the spacer is installed inside the
ski leg, skis are set to the narrower
stance.
When the spacer is installed outside
the ski leg, skis are set to the wider
stance.
To change the ski stance, proceed as
follows on both sides:
1. Lift the front of vehicle.
2. Remove the ski bolt.
3. Place the spacer according to the
desired stance, see illustration.
mbl2007-010-001_b
PARTS LAYOUT - LH SIDE SHOWN
1. Ski stopper
2. Ski bolt
3. Washer
4. Nut
5. Ski leg bushing (in the ski leg bore)
6. Ski leg
9. Spacer inwards-narrow stance
10. Spacer outwards-wide stance
4. Install all the other parts and tighten
nut to specification.
TIGHTENING TORQUE
Ski bolt
48 N•m ± 6 N•m
(35 lbf•ft ± 4 lbf•ft)
NOTE: Make sure your vehicle does
not exceed the maximum width al-
lowed for trail riding. Check local regu-
lations.
Front Springs
Front spring preload has an effect on
front suspension firmness.
Front spring preload also has an effect
on the steering behavior.
108
______________