BRP Ski-Doo 1200 4-TEC 2018, Operator'S Manual

Page: 122 / 211

MAINTENANCE PROCEDURES
mmr2011-070-053_a
UNDERNEATH THE ENGINE
1. Main drain plug
2. Secondary drain plug
8. Allow oil to drain completely.
9. Replace OIL FILTER , see procedure
in this subsection.
10. Install NEW sealing washers on oil
drain plugs.
NOTICE
Never use a sealing
washer a second time. Always re-
place with a new one.
mmr2011-070-004_a
1. Sealing washer
2. Oil drain plug
11. Install drain plugs and tighten to
specification.
TIGHTENING TORQUE
Drain plugs
20 N•m ± 2 N•m
(15 lbf•ft ± 1.5 lbf•ft)
12. Refill oil tank at the proper level
with the recommended oil.
APPROXIMATE ENGINE OIL
CAPACITY (WITH FILTER)
600 ACE
2.1 L
(2.2 qt (U.S. liq.))
900 ACE
3.3 L
(3.5 qt (U.S. liq.))
13. Reinstall dipstick in oil tank and
properly tighten it.
14. Start engine and let it idle for a few
minutes.
15. Ensure there are no leaks.
16. Stop engine and check oil level as
explained in this subsection. Refill
if necessary.
17. Dispose oil and filter as per your lo-
cal environmental regulations.
Engine Oil (1200 4-TEC)
Recommended Engine Oil
RECOMMENDED ENGINE OIL
XPS 4-STROKE SYNTHETIC OIL
(P/N 293 600 112)
NOTICE
The engine of this snow-
mobile has been developed and
validated using the recommended
BRP XPS™ oil. BRP strongly rec-
ommends the use of its recom-
mended XPS oil at all times. Dam-
ages caused by oil which is not suit-
able for the engine will not be cov-
ered by the BRP limited warranty.
If the recommended oil is not available,
use SAE 0W40 synthetic-based oil that
meets or exceeds the requirements
for API service classification SM.
Engine Oil Level Verification
Check engine oil level every 10 hours
or 500 km (300 mi) whichever comes
first.
120
______________