BRP Ski-Doo 1200 4-TEC 2018, Operator'S Manual

Page: 134 / 211

MAINTENANCE PROCEDURES
NOTICE
Do not completely re-
move calibration screw otherwise
internal washers will fall off. Al-
ways adjust all 3 calibration screws
and make sure they are all set to the
same position.
mmo2015-007-303_a
TYPICAL
1. Loosen just enough to permit rotating of
calibrate screw
WARNING
NEVER disassemble or modify the
drive pulley.
Improper assembly or modifica-
tions could cause the pulley to ex-
plode violently under the stress
generated by the high rotational
speed.
See your Ski-Doo dealer to main-
tain or service the drive pulley. Im-
proper servicing or maintenance
may affect performance and re-
duce belt life.
Always respect
maintenance schedules.
WARNING
NEVER operate engine:
– Without shields and belt guard
securely installed.
– With hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
Track
Track Condition
WARNING
Remove tether cord cap from en-
gine cut-off switch before perform-
ing any maintenance or adjust-
ment, unless otherwise specified.
Vehicle must be parked in a safe
place, away from the trail.
Remove tether cord cap from engine
cut-off switch.
Lift the rear of the snowmobile and
support it with a wide-base snowmo-
bile mechanical stand with a rear de-
flector panel. With the engine off, ro-
tate the track by hand, and inspect con-
dition. If worn or cut, or if track fibers
are exposed, or if missing or defective
inserts or guides are noted; contact an
authorized Ski-Doo dealer.
S S S Sn n n no o o ow w w wm m m mo o o ob b b biiiilllle e e es ss s E E E Eq q q qu u u uiiiip p p pp p p pe e e ed d d d w w w wiiiitttth h h h
T T T Trrrra aa ac cc cttttiiiio o o on n n n E E E En n n nh h h ha aa an n n nc cc ciiiin n n ng g g g P P P Prrrro o o od d d du u u uc cc ctttts ss s
If your snowmobile is equipped with
a BRP approved studded track, PRO-
CEED WITH A VISUAL INSPECTION
OF YOUR TRACK BEFORE EACH
USE.
Look for any defects, such as:
– Perforations in the track
– Tears
in the track (particularly
around traction holes on studded
tracks)
– Lugs that are broken or torn off, ex-
posing portions of rods
– Delamination of the rubber
– Broken rods
– Broken studs (studded tracks)
– Bent studs (studded tracks)
– Missing studs
– Studs that are torn off the track
– Missing track guide(s)
– Also, ensure that studs nut are
tighten to specification.
132
______________